Camlok THK Thin Sheet Horizontal Plate Clamps

Camlok THK Thin Sheet Horizontal Plate ClampsThe THK horizontal plate clamps share the same basic design features as the CH range but have a reversed tooth jaw design. This acts as an addictional safety feature specifically for use with thin sheets which may have a tendency to sag or flex. The THK clamps are particularly suited to thin plate with a surface harness less than 300 Brinell 32 Rockwell C.

-  The sleeve must never be installed at less than 85 mm from the edge of the structure

and a hand chain loop that is 500mm from ground level

4 2 Wire Rope Capacity- Upper Layer m 12 15 15 10 Lift Per Crank Rotation mm 138 68 35 35 Required Crank Pressure daN 13 15 13 20 Weight Kg 3 10 11 11

lifting accessories such as webbing slings should be thoroughly examined by a competent person every 6 months

To ensure maximum performance and longevity

even with such a slender profile

The wide polyester webbing helps spread contact pressure across the load when used correctly

(ii) 25metre Replacement rope - diameter 6

skates are excellent quality and great value for money

the user simply pivots the two side plates in the opposite direction and reinstalls the connector which acts as a safety lock

These clamps have been specially designed and manufactured by Camlok for the transportation

- Belt for work positioning