Shrink chuck 4,5° SK 50 - 16 - 160

Shrink chuck 4,5° SK 50 - 16 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Delivery with test certificate All holders are made of forged steel

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

Clamping positions: horizontal

Concentricity: ± 0

- Honed collet boring

With mechanical booster

Without toolholders and inserts

- Preset real position value

Low-vibration boring barsWith internal coolingLonger durability of insertsFor longitudinal and plane turningSetting angle: 93°Delivery: without inserts

For the assembly and disassembly of collets KPS-system

For mounting straight-shank tools according to DIN 1835 form B+E

From d = 25 on two clamping screws