4" OD X 36" Long

4" OD X 36" LongStandard aluminum intake tubing. 6061T6 alloy . 065 wall thickness. Cuts easily with a hack saw. About 1 1 2 inches on each end goes inside an intake hose (minimum 1 inch). Mill finish (as it arrives at our location from the mill after traveling on a truck and being handled several times) may have minor defects and small scratches, but no dents or major defects. Made in USA.

This 2" 45-degree intake hose can be used anywhere you need to join two 5

Recommended clamps are 94100-0388

Recommended clamps are 94100-0450 on the small end and 94100-0550 on the big end

This reducing insert adapts a 7" ID intake hose to a 6-1/4" OD tube

This reducing 45-degree intake elbow can be used any place where you are connecting a 7" OD tube and a 6" OD tube

This 2" ID silicone coupler is 3 inches long and has the special matte red finish indicating aramid reinforcement

use 94100-0275 for that end and 94100-0288 on the big end

90CB25R231

Recommended clamps are 94100-0288

You install it in the end of the 4

This 8-inch ID 45-degree intake hose can be used anywhere you need to join two 8" OD tubes with a 45 degree bend

Temp rated at 250-275F