2.25" ID - Gloss Black

2.25" ID - Gloss BlackThis 90 degree silicone elbow is 2 1 4" ID and can be used any place you need a 90 degree bend. Handles 350 F continuous and is perfect for intercooler aftercooler applications. Five ply reinforced silicone for high strength. Thick 7 32" wall construction. Full 6" leg lengths. Recommended clamps are 94100 0262.

This reducing insert adapts a 2" ID intake hose to a 1-1/2" OD tube

If the small end is mounted to the standard 2-5/16" carb or tube

When a 90 degree elbow is not sharp enough

Recommended clamps are 94100-0400 on the big end and 94100-0350 on the small end

This short 8 inch hump hose is used to connect two 8" OD intake tubes

It will handle 350 F continuous

and then the 6-1/4" tube or tube fits into the insert

Handles 350F continuous and is perfect for intercooler/aftercooler applications

This rubber reducing 45-degree intake elbow can be used any place where you are connecting a 6" OD tube and a 5-1/2" OD tube

and then the 5-1/2" intake tube fits in the hole

Recommended clamps are 94100-0550 on the small end and 94100-0650 on the big end

and then the 3-3/4" intake tube fits in the hole